User Tools

Site Tools


sts1-mission-checklist

STS-1 Mission Checklist

Checklists will look best at a screen resolution of 1280*1024 and above
if you are using lower resolution you might see misaligned text please Do not try and “fix it” for the majority of users do use these screen resolution
COMM MET Panel Section Panel procedure Panel Area & Notes
1105 Mission depending Center Panel



Overhead AFT Panel


Center Panel
C2



C3
O14
O16
C2
* Enter OPS 202 PRO (Right Keypad)
* Enter ITEM 22 EXEC (Right Keypad)
* Confirm ORBITAL DAP/CONTROL Is set To AUTO
* Enter ITEM 27 EXEC (Right Keypad)
* Enter ITEM 23 EXEC (Right Keypad)
* Set OMS ENG (Left & Right) To ARM/PRESS
* Set L OMS ENG VLV To ON
* Set R OMS ENG VLV To ON
* Press EXEC - (Right Keypad) Confirms ready for OMS burn
only required if the CRT is not on ORBIT MNVR display
Orbit Adjustment Burn - (First OMS Burn)





Orbit Adjustment Burn - (Second OMS Burn)
1106 Mission depending Center Panel C3 * Set OMS ENG (Left & Right) To OFF First Orbit Adjustment Complete
Next Event
1110 Mission depending Center Panel C2


C3
C2
* Enter ITEM 22 EXEC (Right Keypad)
* Enter ITEM 27 EXEC (Right Keypad)
* Enter ITEM 23 EXEC (Right Keypad)
* Set OMS ENG (Left & Right) To ARM/PRESS
* Press EXEC - (Right Keypad) Confirms ready for OMS burn
Note: ORBIT MNVR EXEC Should Be Displayed On The CRT.



Note: LOAD Will Be Flashing On The CRT
1111 Mission depending Center Panel C3 * Set OMS ENG (Left & Right) To OFF OMS Burn Complete
1112 Mission depending Columbia Continues Its Mission
Next Event
1115 Mission depending Front Left Panel F6 * Confirm FLT CNTLR POWER Is ON Shuttle Translation Test
Shuttle Translation Test

Translate the shuttle around as you wish. This is a great opportunity to see how the shuttle performs.
The orbital digital auto pilot (ORBITAL DAP) push buttons on the CENTER PANEL (C3), control the behavior of the Translation/Rotation actions.
In PULSE mode the RCS fires short burst each time the joystick is deflected.
In DISC RATE mode the RCS fires for as long as you deflect the joystick, the RCS will fire Counter-Bursts once the joystick is released until the shuttle stabilizes
The PRI, ALT and VERN modes select different dead bands size and rates of thrust. VERN mode uses dedicated RCS’s and is used for final attitude adjustments.
VERN mode conserves fuel and is the primary mode used while in orbit.
The LOW Z & HIGH Z translation modes select whether any up-firing jets are allowed to fire.


Once the translation tests are complete, Select NEXT EVENT and follow the Deorbit & Landing Checklist



sts1-mission-checklist.txt · Last modified: 2008/11/12 06:52 by uri_ba